WST FBM200A Manual do Operador descarregar pdf (Página 13)

Receiver Sensitivity

The receiver sensitivity can be adjusted for each application. To

receive beacon bursts from far away, set the sensitivity to the highest

level of -125 dBm. This setting will receive bursts from near also.

To receive only the beacons that are near, set the sensitivity to the

lowest level of -55 dBm.

The default sensitivity level is -115 dBm.

The Beacon Monitor has sophisticated algorithms for preventing false

triggering. However, burst reception may be hindered when operating

the Beacon Monitor in an electrically noisy environment. You may need

to remove the source of interference or reduce the sensitivity of the

Beacon Monitor.

To monitor the ratio of interference events versus valid burst events, go

to the Receiver Information screen in Setup Mode. The Burst Counter

will show the number of invalid bursts, the number of valid bursts, and

the elapsed time in minutes. The Burst Counter numbers are reset

each time the Beacon Monitor application is started.

Click on the Apply button whenever a change is made.

Apply

button

Slider

bars

button

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Sem comentários

WST FBM200A Manual do Operador Página 13